Read me

file:///T|/htdocs/SOFTWARE/svradmin/6.2/en/README/readme.txt[10/26/2012 3:03:00 PM]
for a degraded RAID 1-concatenated virtual disk may display the
"Check Consistency" option. Do not perform a consistency
check until appropriate actions are performed to restore the
virtual disk. Dell is working to resolve this problem.
* With Chinese or Japanese language browser settings, using the
Storage Management Service Advanced Create VDisk Wizard may
occasionally result in text overflowing to the bottom of the
side-by-side blue text boxes.
====================================================================
ISSUES FOR REMOTE ACCESS
====================================================================
NOTE: The Remote Access Service is supported on
xx1x systems only.
The following subsections list the currently known issues regarding
implementation and operation of your RAC and the Remote Access
Service in Server Administrator.
--------------------------------------------------------------------
ISSUES FOR ALL OPERATING SYSTEMS
--------------------------------------------------------------------
* Server Administrator user interface and commands related to "local
authentication enable" are not applicable for RAC firmware 3.20.
The Active Directory authentication feature replaces the "local
operating system authentication" feature in this version of
firmware. Due to this change, the following commands will return
errors:
"racadm localauthenable"
"omconfig rac authentication"
* Due to fluctuations in the watchdog timer, the "Last Crash
Screen" may not be captured when the Automatic System Recovery is
set to a value of less than 30 seconds. To ensure correct
functioning of the “Last Crash Screen” feature, set the System
Reset Timer to at least 30 seconds.
* The cfgDNSServer1 and cfgDNSServer2 properties of group
cfgLanNetworking may be set to identical values while swapping
addresses. Some performance may be lost temporarily during the
swapping. The cfgLanNetworking group is configured using the
"racadm config" command.[132894]
* The remote access controller uses FTP protocol to perform some of
the Dell OpenManage commands. If a firewall is installed in the
system, it may cause these commands to fail.
The following Server Administrator CLI commands use FTP protocol
to communicate with the RAC: