Read me

file:///T|/htdocs/SOFTWARE/svradmin/6.2/en/README/readme.txt[10/26/2012 3:03:00 PM]
* Due to the limitation of VMware ESX 3i/4i, the “About” tab in the
Server Administrator Preferences page will display 'Preferences Preferences'
instead of 'Server Administrator Preferences.'
[276236]
* While trying to manage a system running the VMware ESXi version 4
operating system from Server Administrator Web Server, an “Internal Error”
message may be displayed if the management agent stops responding.
[289096]
* Some Server Administrator CLI commands may function properly only when
they are run from the elevated console window. Therefore, it is
recommended that you use the elevated console for running the CLI.
[315853]
* The Remote Management feature is not supported on the system running
VMWare ESX 3.5 operating system, either as a Server Administrator Web server
or a Remote Enablement Agent. If you use systems running VMWare ESX 3.5
operating system as a Server Administrator Web server or as a
Remote Enablement Agent, a "login failed" message will be displayed
while managing it as a remote node (s). On VMWare ESX 3.5 based managed
systems, even though the remote enablement option is available,
it is not supported when actually installed. You can manage VMWare ESX 3.5
based system as a local node.
[280822,330584,330615]
* Time zone changes which are applied manually or through the network
time server will not take effect in Server Administrator unless you
restart Server Administrator services.
In addition you will need to restart the following services
if Remote Enablement is installed.
For Windows Operating Systems:
- Windows Management Instrumentation Service
- Windows Remote Management (WS-Management)
For Linux Operating Systems:
- SFCB daemon (/etc/init.d/sfcbd)
- Open-WSMan daemon (/etc/init.d/openwsmand)
[329124]
* In case of Power Monitoring statistics, reset the values
after restart of Server Administrator services for time zone changes
to take effect.
[329124]
* If the IDSDM (Internal Dual SD Module) Redundancy is disabled through
the (F2) BIOS Setup and the system is rebooted with IDSDM card installed,
then the Internal Dual SD Module Redundancy section will not be reported
on the Removable flash media information page or the corresponding
CLI command i.e. omreport chassis removableflashmedia.
[349628]