Users Guide
Table Of Contents
- User’s Guide
- Introduction
- What’s New for Version 6.1
- Setup and Administration
- Using Server Administrator
- Server Administrator Services
- Working With Remote Access Controller
- Overview
- Viewing Basic Information
- Configuring the Remote Access Device to use a LAN Connection
- Configuring the Remote Access Device to use a Serial Port Connection
- Configuring the Remote Access Device to use a Serial Over LAN Connection
- Additional Configuration for iDRAC
- Configuring Remote Access Device Users
- Setting Platform Event Filter Alerts
- Server Administrator Logs
- Setting Alert Actions
- Troubleshooting
- Frequently Asked Questions
- Glossary
- Index
92 Working with Remote Access Controller
6
Configure the following IPv4 Properties:
• IP Address Source
• IP Address
• Subnet Mask
• Gateway Address
7
Configure the following IPv6 Properties:
• IP Address Source
• IP Address
• Prefix Length
• Default Gateway
• DNS Address Source
• Preferred DNS Server
• Alternate DNS Server
NOTE: You will be able to configure the IPv4 and IPv6 address details only if
you enable the IPv4 and IPv6 properties under Additional Configuration.
8
Click
Apply Changes.
Configuring the Remote Access Device to use a
Serial Port Connection
You can configure the BMC for communication over a serial port connection.
To do this:
1
Click the
Modular Enclosure
→
System/Server Module
→
Main System
Chassis/Main System
→
Remote Access
object.
2
Click the
Configuration
tab.
3
Click
Serial Port
.
The
Serial Port Configuration
window appears.
4
Configure the following details:
• Connection Mode Setting
•Baud Rate
• Flow Control
• Channel Privilege Level Limit
book.book Page 92 Monday, June 22, 2009 11:05 AM