User's Manual

58 omreport: Viewing System Status Using the Instrumentation Service
• Maximum Output Wattage
• Online Status
• Power Monitoring Capable
omreport chassis remoteaccess/omreport mainsystem remoteaccess
Use the omreport chassis remoteaccess or omreport mainsystem
remoteaccess command to view general information on baseboard
management controller or integrated Dell remote access controller
(BMC/iDRAC) and
remote access controller if DRAC is installed.
Type:
omreport chassis remoteaccess
or
omreport mainsystem remoteaccess
NOTE: This command is applicable to PowerEdge x8xx, x9xx, xx0x, and xx1x
systems only.
The output of the omreport chassis remoteaccess/omreport mainsystem
remoteaccess command lists each of the valid parameters. Table 3-6 shows
the available settings.
Table 3-6. omreport chassis remoteaccess/omreport mainsystem remoteaccess
name=value pair Description
config=additional Reports the current state of IPv4 and IPv6 addresses on
iDRAC6.
config=advsol Reports advanced BMC/iDRAC6 or remote access information
on a serial over local area network (LAN) connection.
config=nic Reports BMC/iDRAC6 or remote access information for the
LAN.
config=serial Reports serial port information for BMC or remote access.
config=serialoverlan Reports BMC/iDRAC6 or remote access information on a serial
over LAN connection.
config=
terminalmode
Reports terminal mode settings for the serial port.
config=user Reports information on BMC/iDRAC6 or remote access users.