User's Manual

254 Glossary
DTE
Abbreviation for data terminal equipment. Any device, such as a computer system,
that can send data in digital form by means of a cable or communications line.
The DTE is connected to the cable or communications line through a data
communications equipment (DCE) device, such as a modem.
ECC
Abbreviation for error checking and correction.
ECP
Abbreviation for Extended Capabilities Port.
EDO
Acronym for extended data output dynamic random access memory which is a
type of DRAM faster than conventional DRAM. EDO RAM can start fetching
the next block of memory at the same time that it sends the previous block to
the CPU.
EEPROM
Acronym for electrically erasable programmable read-only memory.
EIDE
Abbreviation for enhanced integrated drive electronics. EIDE devices add one or
more of the following enhancements to the traditional IDE standard:
• Data transfer rates of up to 16 MB/sec
• Support for drives other than just hard drives, such as CD drives
• Support for hard drives with capacities greater than 528 MB
• Support for up to two controllers, each with up to two devices attached
EISA
Acronym for Extended Industry-Standard Architecture, a 32-bit expansion-bus
design. The expansion-card connectors in an EISA computer are also compatible
with 8- or 16-bit ISA expansion cards.
To avoid a configuration conflict when installing an EISA expansion card, use the
EISA Configuration Utility. This utility allows you to specify which expansion
slot contains the card and obtains information about the card's required system
resources from a corresponding EISA configuration file.