User's Manual

Using the Storage Management Service 177
omreport Physical Disk Status
Table 6-13 describes the syntax for the omreport Physical Disk Commands
Table 6-13. omreport Physical Disk Commands
Required Command Levels (1, 2, 3)
and name=value pair
Optional name=value pairs Use
omreport storage pdisk controller=id
where id is the controller
number. For example:
controller=0
Displays all physical disks
attached to the specified
controller.
NOTE: If a physical disk
was replaced by another
disk as part of the replace
member operation, the
state of the physical disk is
displayed as
Replacing.
connector=id
where id is the connector
number. For example:
connector=1
Displays all physical disks
attached to the specified
connector on the
controller.
vdisk=id
where id is the virtual disk
number. For example:
vdisk=1
Displays all physical disks
included in the specified
virtual disk on the
controller.
pdisk=connectorID :
targetID | connectorID :
enclosureID : slotID
where
connectorID:targetID is
the connector number
and the physical disk
number and
connectorID:enclosureID:s
lotID is the connector
number, enclosure
number, and slot number.
For example: pdisk=0:2
or pdisk=0:1:2
Displays the specified
physical disk on the
specified connector on the
controller.