User's Manual

Using the Storage Management Service 167
Table 6-2. Syntax For Name=Value Pairs For Parameters
Syntax Description
controller=id Indicates the controller ID as reported by the omreport storage
controller command. To obtain these values, enter omreport
storage controller to display the controller IDs and then
enter omreport storage pdisk controller=id to
display the IDs for the physical disks attached to the controller.
For example, the controller=id parameter might be specified as
controller=1.
connector=id Indicates the connector ID as reported by the omreport
command. To obtain this value, enter omreport storage
controller to display the controller IDs and then enter
omreport storage connector controller=id to
display the IDs for the connectors attached to the controller.
For example, the connector=id parameter might be specified as
connector=2.
vdisk=id Indicates the virtual disk ID as reported by the omreport
command. To obtain this value, enter omreport storage
controller to display the controller IDs and then enter
omreport storage vdisk controller=id to display
the IDs for the virtual disks on the controller.
For example, the vdisk=id parameter might be specified as
vdisk=3.
enclosure=
<ENCLOSUREID
>
Indicates a particular enclosure by specifying either enclosure=
connector or enclosure=connector:enclosureID.
To obtain these values, enter omreport storage
controller to display the controller IDs and then enter
omreport storage enclosure controller=id to
display the IDs for the enclosures attached to the controller.
pdisk=
<PDISKID>
Indicates a particular physical disk by specifying either
connector:targetID or connector:enclosureID:portID.
To obtain the values for the connector, enclosure, and physical
disk (targetID or portID), enter omreport storage
controller to display the controller IDs and then enter
omreport storage pdisk controller=id to display
the IDs for the physical disks attached to the controller.