User's Manual

omconfig: Managing Components Using the Instrumentation Service 139
omconfig system events/omconfig servermodule events
Use the omconfig system events or omconfig servermodule events command
to enable and disable SNMP traps for the components on your system.
NOTE: Not all event types may be present on your system.
There are four parameters in the name=value pair component of the
omconfig system events command:
•Source
•Type
• Severity
• Index
Source
At present, source=snmptraps is a required name=value pair because
SNMP is currently the only supported source of event notification for your
system’s components.
omconfig system events source=snmptraps
or
omconfig servermodule events source=snmptraps
Typ e
Type refers to the name of the component(s) involved in the event.
Table 4-27 shows the valid parameters for system event types.
event=voltfail Sets action or enables/disables alert generation when a
voltage probe detects that the voltage is too low for proper
operation.
event=watchdogasr Enables or disables alert generation configured by the ASR
when the system has hung or is not responding.
Table 4-26. omconfig system platformevents (continued)
Event Name Description