Read me

file:///T|/htdocs/SOFTWARE/svradmin/6.1/en/README/readme.txt[10/19/2012 2:06:29 PM]
reboot system) to recover a hung system. Since the Auto Recovery
timer is now an application level timer instead of a kernel level
timer, heavy resource stress on the system makes it more likely
that a short keep alive interval (less than 120 seconds) will not
be measured accurately, and the configured action may be
triggered.
The issue will be more prevalent in systems that have only one
CPU with hyper-threading unsupported /disabled or systems that
are subjected to persistent stressful conditions, such as resource
depletion and CPU running at 100% usage with significantly more
threads than normal usage.
The Auto Recovery feature is not enabled by default. If the Auto
Recovery feature has been enabled, increase the System Reset Timer
value to at least 120 seconds. [78425]
* Using Internet Explorer browser, if you install Server Administrator
on a system that includes a underscore in its hostname, you must use
the target system's ip address in the browser's URL to launch Server
Administrator, as Hostnames, with underscores are not supported.
For example (assuming Server Administrator is listening on port
1311): https://192.168.2.3:1311. For more information, see the
following article on the:
Microsoft website:http://support.microsoft.com/kb/312461
* If the Alert Log contains large number of entries and if you try
to navigate to other page Server Administrator GUI may become
unresponsive and may take approximately 30 seconds. [152755]
* On certain systems that do not support power monitoring, Server
Administrator reports the two platform event filters related to
power monitoring as "System Power Probe Warning" and "System Power
Probe Failure". These two filters are not supported on these
systems. That is, you can view and configure these filters;
however no action will be taken. [172125]
* On Server Administrator, Under Asset Information->System
Information->Primary User Telephone Number configuration allows
only alphanumerics. [185770]
* The selection of default option for front panel LCD in Server
Administrator will display Model Name where as the default is
Service Tag on the physical LCD.
* In case server administrator does not respond/locked to your
selections on the component tree, perform the following steps.
1. Click on Preferences. The preferences page appears
2. Click on the Server administrator
3. Now the items on the front page might respond to your click.