Messages Reference Guide

Index 249
The initialization sequence of
SAS components failed
during system startup. SAS
management and monitoring
is not possible., 199
The non-RAID SCSI driver
version is older than the
minimum required level.See
the Readme file for the
validated driver version., 141
The NVRAM has corrupt
data., 206
The NVRAM has corrupted data.
The controller is
reinitializing the
NVRAM., 206
The Patrol Read corrected a
media error., 178
The patrol read has
resumed., 185
The Patrol Read has started., 167
The Patrol Read has
stopped., 167
The Patrol Read is paused., 185
The Patrol Read mode has
changed., 166
The Patrol Read rate has
changed., 165
The physical disk blink has
ceased., 170
The physical disk blink has
initiated., 170
The physical disk Clear
operation failed., 178
The physical disk Clear
operation has
completed., 177
The physical disk Clear
operation has started., 169
The physical disk has been
started., 171
The physical disk is not
certified., 221
The physical disk is not
supported., 158
The physical disk is too small to
be used for a rebuild., 194
The physical disk rebuild has
resumed., 180
The power supply cable has been
inserted., 204
The power supply is switched
on., 203
The RAID controller firmware
and driver validation was not
performed. The
configuration file cannot be
opened., 139
The RAID controller firmware
and driver validation was not
performed. The
configuration file is out of
date or corrupted., 139
The rebuild failed due to errors
on the source physical
disk., 216