Users Guide

omconfig storage battery action=delaylearn controller=1 battery=0 days=3 hours=12

omconfig Connector Commands

The following sections provide the omconfig command syntax required to execute connector tasks.

Table 17-19. omconfig Connector Commands

omconfig Rescan Connector

Does my controller support this feature? See "Supported Features."

Use the following omconfig command to rescan a controller connector. This command rescans all connectors on the controller and is therefore similar to
performing a controller rescan.

Complete Syntax

omconfig storage connector action=rescan controller= id connector=id

where id is the controller ID and the connector ID as reported by the omreport command. To obtain these values, you would enter omreport storage controller
to display the controller IDs and then enter omreport storage connector controller=ID to display the IDs for the connectors attached to the controller.

Example Syntax

For example, to rescan connector 2 on controller 1, you would enter:

omconfig storage connector action=rescan controller=1 connector=2

omconfig Enclosure Commands

The following sections provide the omconfig command syntax required to execute enclosure tasks.

Table 17-20. omconfig Enclosure Commands
Required Command Levels (1, 2, 3)
Optional name=value Pairs
Documentation Section
omconfig storage connector
action=rescan controller=id connector=id
"omconfig Rescan Connector"
Required Command Levels
(1, 2, 3)
Optional name=value Pairs
Documentation Section
omconfig storage enclosure






action=enablealarm controller=id enclosure=<ENCLOSUREID>
"omconfig Enable Enclosure Alarm"
action=disablealarm controller=id enclosure=<ENCLOSUREID>
"omconfig Disable Enclosure Alarm"
action=setassettag controller=id enclosure=<ENCLOSUREID>
assettag=<string>
"omconfig Set Enclosure Asset Tag"
action=setassetname controller=id enclosure=<ENCLOSUREID>
assetname=<string>
"omconfig Set Enclosure Asset Name"