Users Guide
omconfig storage vdisk action=pausecheckconsistency controller=id vdisk=id
where id is the controller ID and virtual disk ID as reported by the omreport command. To obtain these values, you would enter omreport storage controller to
display the controller IDs and then enter omreport storage vdisk controller=ID to display the IDs for the virtual disks attached to the controller.
Example Syntax
For example, to pause a check consistency on virtual disk 4 on controller 1, you would enter:
omconfig storage vdisk action=pausecheckconsistency controller=1 vdisk=4
omconfig Resume Check Consistency
Does my controller support this feature? See "Supported Features."
Use the following omconfig command syntax to resume a check consistency after it has been paused.
Complete Syntax
omconfig storage vdisk action=resumecheckconsistency controller=id vdisk=id
where id is the controller ID and virtual disk ID as reported by the omreport command. To obtain these values, you would enter omreport storage controller to
display the controller IDs and then enter omreport storage vdisk controller=ID to display the IDs for the virtual disks attached to the controller.
Example Syntax
For example, to resume a check consistency on virtual disk 4 on controller 1, you would enter:
omconfig storage vdisk action=resumecheckconsistency controller=1 vdisk=4
omconfig Delete Virtual Disk
Does my controller support this feature? See "Supported Features."
Use the following omconfig command syntax to delete a virtual disk.
Complete Syntax
omconfig storage vdisk action=deletevdisk controller= id vdisk=id
CAUTION: Deleting a virtual disk destroys all information including file systems and volumes residing on the virtual disk. You may receive a
warning message if you attempt to delete the system or boot partition. However, this warning message is not generated in all circumstances. You
should be certain that you are not deleting the system or boot partition or other vital data when using this command.