Users Guide
To set the Dedicated Hot Spare Protection Policy for RAID 10 with severity level=warning if the threshold level of 2 hot spares is exceeded, enter the following:
omconfig storage globalinfo action= setprotectionpolicies type=dhs raid=r1 hscount=2 warnlevel=2
omconfig Controller Commands
The following sections provide the omconfig command syntax required to execute controller tasks.
Table 17-15.omconfigControllerCommands
Required
Command
Levels (1, 2,
3)
Optional name=value Pairs
Documentation
Section
omconfig
storage
controller
action=rescan controller=id
"omconfig Rescan
Controller"
action=enablealarm controller=id
"omconfig Enable
Controller Alarm"
action=disablealarm controller=id
"omconfig Disable
Controller Alarm"
action=quietalarm controller=id
"omconfig Quiet
Controller Alarm"
action=testalarm controller=id
"omconfig Test
Controller Alarm"
action=resetconfig controller=id [force=yes]
"omconfig Reset
Controller
Configuration"
action=createvdisk controller=id raid=<c| r0| r1| r5| r6 | r10| r50 | r60> size=<number | max | min>
pdisk=<PDISKID> [stripesize=< 2kb| 4kb| 8kb| 16kb| 32kb| 64kb| 128kb>] [cachepolicy=<d | c>]
[diskcachepolicy=<d | e>] [readpolicy=<ra| nra| ara| rc| nrc>] [writepolicy=<wb | wt | wc | nwc | fwb>]
[name=<string>] [spanlength=<n>]
NOTE: For RAID 10 on SAS controllers with firmware version 6.1 and later, spanlength is an optional parameter
(default=2)
"omconfig Create
Virtual Disk"
action=setrebuildrate controller=id rate=<0 to 100>
"omconfig Set
Controller Rebuild
Rate"
action=setbgirate controller=id rate=<0 to 100>
"omconfig Set
Background
Initialization Rate"
action=setreconstructrate controller=id rate=<0 to 100>
"omconfig Set
Reconstruct Rate"
action=setcheckconsistency controller=id rate=<0 to 100>
"omconfig Set Check
Consistency Rate"
action=exportlog controller=id
"omconfig Export the
Controller Log"
action=importforeignconfig controller=id
"omconfig Import
Foreign
Configuration"
action=importrecoverforeignconfig controller=id
"omconfig
Import/Recover
Foreign
Configuration"
action=clearforeignconfig controller=id
"omconfig Clear
Foreign
Configuration"
action=setpatrolreadmode controller=id mode=manual|auto|disable
"omconfig Set Patrol
Read Mode"
action=startpatrolread controller=id
"omconfig Start
Patrol Read"
action=stoppatrolread controller=id
"omconfig Stop
Patrol Read"
action=setchangecontrollerproperties controller=<id> abortcheckconsistencyonerror=<enabled/disabled>
allowreplacemember=<enabled/disabled> loadbalance=<auto/disabled>
autoreplacememberonpredictivefailure=<enabled/disabled> bgirate=<rate> reconstructrate=<rate>
rebuildrate=<rate> checkconsistencyrate=<rate> redundantpathview=disabled
"omconfig Change
Controller Properties"
action=discardpreservedcache controller=id force=e|d
"omconfig Storage
Controller"