Users Guide

Drop-down Menu Enclosure Tasks:
l "Enable Alarm (Enclosure)"
l "Disable Alarm (Enclosure)"
l "Set Asset Data"
l "Blink"
l "Set Temperature Probe Values"

Enable Alarm (Enclosure)

Does my enclosure support this feature? See "Supported Features."

Use the Enable Alarm task to enable the enclosure alarm. When enabled, the audible alarm sounds whenever the fault LED lights. This may occur to signal
events such as:
l The enclosure temperature has exceeded the warning threshold.
l A power supply, fan, or enclosure management module (EMM) has failed.
l The split bus is not installed. (A split bus is indicated by a single triangle symbol on the back of the enclosure.)

Disable Alarm (Enclosure)

Does my enclosure support this feature? See "Supported Features."

Use the Disable Alarm task to disable the enclosure alarm. When disabled, the alarm does not sound when the enclosure exceeds a warning threshold for
temperature or experiences other error conditions such as a failed fan, power supply, or controller. If the alarm is already sounding, you can turn it off with
this task.

Set Asset Data

Does my enclosure support this feature? See "Supported Features."

Use the Set Asset Data task to specify the enclosure's asset tag and asset name. See "Set Asset Data" for more information.

Blink

Does my enclosure support this feature? See "Supported Features."

Use the Blink task to blink the light-emitting diodes (LEDs) on the enclosure. You may want to use this task to locate an enclosure. The LEDs on the enclosure
may display different colors and blinking patterns. Refer to the enclosure hardware documentation for more information on what the blink colors and patterns
indicate.

Set Temperature Probe Value

Does my enclosure support this feature? See "Supported Features."

Use the Set Temperature Probe Values task to specify the Warning and Failure thresholds for the enclosure's temperature probes. See "Set Temperature
Probe Values" for more information.