User's Manual

Example for SAS Controllers:
In this example, the temperature probes reside in enclosure 3 attached to connector 0 on controller 1. To set the thresholds for all temperature probes to 10
Celsius and 40, you would enter:
omconfig storage enclosure action=setalltempprobes controller=1 enclosure=0:3 minwarn=10 maxwarn=40
See "enclosure=<ENCLOSUREID> Parameter on SAS Controllers" for more information on enclosure specification. See "RAID Controller Technology: SCSI, SATA,
ATA, and SAS" to identify which technology a controller uses.

omconfig Reset All Temperature Probe Thresholds

Does my enclosure support this feature? See "Supported Features."
Use the following omconfig command syntax to reset the minimum and maximum warning temperature thresholds back to their default value for all
temperature probes in the enclosure.

Complete Syntax
omconfig storage enclosure action=resetalltempprobes controller=id enclosure=<ENCLOSUREID>
where id is the controller ID. The <ENCLOSUREID> variable specifies the enclosure. See "enclosure=<ENCLOSUREID> Parameter" for more information.

Example Syntax
For example, you may want to reset the thresholds for all temperature probes in enclosure 2 on controller 1.

Example for SAS Controllers:
In this example, the temperature probes reside in enclosure 3 attached to connector 0 on controller 1. To reset the thresholds for all temperature probes, you
would enter:
omconfig storage enclosure action=resetalltempprobes controller=1 enclosure=0:3
See "enclosure=<ENCLOSUREID> Parameter on SAS Controllers" for more information on enclosure specification. See "RAID Controller Technology: SCSI, SATA,
ATA, and SAS" to identify which technology a controller uses.

omconfig Blink

Does my enclosure support this feature? See "Supported Features."
Use the following omconfig command to blink the light-emitting diodes (LEDs) on the enclosure.

Complete Syntax
omconfig storage enclosure action=blink controller=id enclosure=<ENCLOSUREID>
where id is the controller ID. The <ENCLOSUREID> variable specifies the enclosure. See "enclosure=<ENCLOSUREID> Parameter" for more information.

Example for SCSI, SATA, and ATA Controllers:
For example, to blink the LEDs for the enclosure attached to connector 2 on controller 1, you would enter:
omconfig storage enclosure action=blink controller=1 enclosure=2
See "enclosure=<ENCLOSUREID> Parameter on SCSI, SATA, and ATA Controllers" for more information on enclosure specification. See "RAID Controller
Technology: SCSI, SATA, ATA, and SAS" to identify which technology a controller uses.

Example for SAS Controllers:
For example, to blink the LEDs for enclosure 3 attached to connector 0 on controller 1, you would enter: