User's Manual

omconfig storage pdisk action=clear controller=1 pdisk=0:2:3
See "pdisk=<PDISKID> Parameter on SAS Controllers" and "Multiple Targets" for more information on physical disk specification. See "SAS RAID Controllers" to
identify which controllers use SAS technology.

omconfig Cancel Clear Physical Disk

Does my controller support this feature? See "Supported Features."
Use the following omconfig command to cancel a clear operation that is in progress on a physical disk.

Complete Syntax
omconfig storage pdisk action=cancelclear controller=id pdisk=<PDISKID>
where id is the controller ID. The <PDISK> variable specifies the physical disk. See "pdisk=<PDISKID> Parameter" for more information.
To obtain these values, you would enter omreport storage controller to display the controller IDs and then enter omreport storage pdisk controller=ID to
display the IDs for the physical disks attached to the controller.

Example for SAS Controllers:
In this example, you want to cancel the clear of physical disk 3 on connector 0 of controller 1. The physical disk resides in enclosure 2. To cancel the clear of
the physical disk described in this example, you would enter:
omconfig storage pdisk action=cancelclear controller=1 pdisk=0:2:3
See "pdisk=<PDISKID> Parameter on SAS Controllers" and "Multiple Targets" for more information on physical disk specification. See "SAS RAID Controllers" to
identify which controllers use SAS technology.

omconfig Cancel Replace Member

Does my controller support this feature? See "Supported Features."
Use the following omconfig command syntax to cancel a replace member operation.

Complete Syntax
action=cancelreplacemember controller=id pdisk=<PDISKID>
where id is the physical disk IDs as reported by the omreport command.

Example Syntax
For example, to cancel replace member operation on physical disk 0:0:1, which is connected to controller 0, you would enter:
omconfig storage pdisk action=cancelreplacemember controller=0 pdisk=0:0:1
omconfig Battery Commands
The following sections provide the omconfig command syntax required to execute battery tasks.
Table 15-18. omconfig Battery Commands

Required Command Levels (1, 2, 3)

Optional name=value Pairs

Documentation Section
omconfig storage battery


action=recondition controller=id battery=id
"omconfig Recondition Battery"
action=startlearn controller=id battery=id
"omconfig Start Battery Learn Cycle"