User's Manual


omreport Power Supply Status
Table 15-10. omreport Power Supply Commands

omreport EMM Status
Table 15-11. omreport EMM Commands

omreport Physical Disk Status
Table 15-12.omreportPhysicalDiskCommands
where id is the controller number and <ENCLOSUREID> is the enclosure ID and n
is the number of a fan. Example for SCSI controllers: controller=0 enclosure=2
info=fans index=1. Example for SAS controllers: controller=0 enclosure=1:2
info=fans index=1.
"enclosure=<ENCLOSUREID> Parameter" for more
information on specifying enclosures.

Required
Command
Levels (1, 2,
3)

Optional name=value Pairs

Use
omreport
storage
enclosure

Displays property information for all enclosures
attached to the system.
controller=id enclosure=<ENCLOSUREID> info=pwrsupplies
where id is the controller number and <ENCLOSUREID> is the enclosure ID.
Example for SCSI controllers: controller=0 enclosure=2 info=pwrsupplies. Example
for SAS controllers: controller=0 enclosure=1:2 info=pwrsupplies.
Displays the power supplies for the specified
enclosure. See "enclosure=<ENCLOSUREID>
Parameter" for more information on specifying
enclosures.
controller=id enclosure=<ENCLOSUREID> info=pwrsupplies index=n
where id is the controller number and <ENCLOSUREID> is the enclosure ID and n is
the number of a power supply. Example for SCSI controllers: controller=0
enclosure=2 info=pwrsupplies index=1. Example for SAS controllers: controller=0
enclosure=1:2 info=pwrsupplies index=1.
Displays the specified power supply. See
"enclosure=<ENCLOSUREID> Parameter" for more
information on specifying enclosures.
NOTE: The status of the EMMs is displayed as degraded if there is a mismatch between the EMM firmware.

Required
Command
Levels (1, 2,
3)

Optional name=value Pairs

Use
omreport
storage
enclosure

Displays property information for all enclosures attached to
the system.
controller=id enclosure=<ENCLOSUREID> info=emms
where id is the controller number and <ENCLOSUREID> is the enclosure ID.
Example for SCSI controllers: controller=0 enclosure=2 info=emms. Example
for SAS controllers: controller=0 enclosure=1:2 info=emms.
Displays the enclosure management modules (EMMs) for
the specified enclosure. See "enclosure=<ENCLOSUREID>
Parameter" for more information on specifying enclosures.
controller=id enclosure=<ENCLOSUREID> info=emms index=n
where id is the controller number and <ENCLOSUREID> is the enclosure ID
and n is the number of an EMM. Example for SCSI controllers: controller=0
enclosure=2 info=emms index=1. Example for SAS controllers: controller=0
enclosure=1:2 info=emms index=1.
Displays the specified EMM. See
"enclosure=<ENCLOSUREID> Parameter" for more
information on specifying enclosures.

Required Command
Levels (1, 2, 3) and
name=value Pair

Optional name=value Pairs

Use
omreport storage
pdisk controller=id
where id is the
controller number. For
example: controller=0

Displays all physical disks attached to the
specified controller.

NOTE: If a physical disk was replaced by
another disk as part of the replace member
operation, the state of the physical disk is
displayed as Replacing. See "Revertible Hot
Spare" for more information.