User's Manual


5. Select the Physical Disks object.

6. Select Clear from the Available Tasks drop-down menu of the physical disk you want to clear.

7. Click Execute.
Revertible Hot Spare
Does my controller support this feature? See "Supported Features."
Use the Revertible Hot Spare task to copy data back from a hot spare to a physical disk.
If the physical disk in a virtual disk fails, the data on the failed disk is copied to the assigned hot spare. If you replace the failed disk with a new physical disk
and if you have enabled the revertible hot spare task, the data is copied from the erstwhile hot spare to the new disk.
You can also use the Revertible Hot Spare task to copy data from a physical disk to the hot spare on a predictive failure event.
If Revertible Hot Spare is enabled and the physical disk is SMART-enabled, the controller firmware automatically starts copying data from the SMART-enabled
disk in the virtual disk to the hot spare.

To enable Revertible Hot Spare:

1. On the Change Controller Properties page, enable Revertible Hot Spare and Auto replace on predictive failure.

2. Click Apply Changes.

To locate this task in Storage Management:

1. Expand the Storage tree object to display the controller objects.

2. Select a controller object on which you want to enable the revertible hot spare task and select the Information/Configuration tab.

3. From the Controller Task drop down menu, select Change Controller Properties and click Execute.
Back to Contents Page

NOTE: To use the Revertible Hot Spare task, you should have assigned a hot spare to the virtual disk.
NOTE: If the disk is not SMART-enabled or if the Auto Replace on Predictive Failure option is disabled, the failed disk will not be replaced automatically.
NOTE: The Rebuild rate for Revertible Hot Spare will be the same as defined for the controller.