Quick Reference Guide

Index 221
The initialization sequence of
SAS components failed
during system startup. SAS
management and monitoring
is not possible., 176
The non-RAID SCSI driver
version is older than the
minimum required level.See
the Readme file for the
validated driver version., 130
The NVRAM has corrupt
data., 181
The NVRAM has corrupted data.
The controller is
reinitializing the
NVRAM., 181
The only hot spare available is a
SAS disk. SAS disks cannot
replace SATA disks., 143
The only hot spare available is a
SATA disk. SATA disks
cannot replace SAS
disks., 143
The Patrol Read corrected a
media error., 159
The patrol read has
resumed., 165
The Patrol Read has started., 151
The Patrol Read has
stopped., 152
The Patrol Read is paused., 165
The Patrol Read mode has
changed., 151
The Patrol Read rate has
changed., 150
The physical disk blink has
ceased., 154
The physical disk blink has
initiated., 153
The physical disk Clear
operation failed., 159
The physical disk Clear
operation has
completed., 158
The physical disk Clear
operation has started., 153
The physical disk has been
started., 154
The physical disk is not
certified., 195
The physical disk is not
supported., 144
The physical disk is too small to
be used for a rebuild., 172
The physical disk rebuild has
resumed., 161
The power supply cable has been
inserted., 180
The power supply is switched
on., 180
The RAID controller firmware
and driver validation was not
performed. The
configuration file cannot be
opened., 128