Manualshelf

Owner's Manual

ManualsBrandsDell ManualsSoftwareDell OpenManage Server Administrator Version 6.0.3
10111213141516171819
file:///T|/htdocs/SOFTWARE/svradmin/6.0.3/readme/readme.txt[10/23/2012 1:29:23 PM]
functioning of the Last Crash Screen feature, set the "System
Reset Timer to at least 30 seconds.
* The cfgDNSServer1 and cfgDNSServer2 properties of group
cfgLanNetworking may be set to identical values while swapping
addresses. Some performance may be lost temporarily during the
swapping. The cfgLanNetworking group is configured using the
"racadm config" command.[132894
* If the RAC configuration is reset to factory defaults using the
"racadm racresetcfg" command, the RAC configuration tab in Server
Administrator does not reflect the reset configuration settings
until the system reboots. Also, the RAC configuration page in
Server Administrator cannot be used to make any configuration
changes until the system reboots.
* The RAC does not support local RAC user IDs with special
characters. When adding a local RAC user, use only alphanumeric
characters for the user name.
* While the RAC is being reset, the Instrumentation Service cannot
read sensor data for certain systems. As a result, the voltage,
temperature, and other probes may not be visible on the Server
Administrator home page until the RAC has completed resetting.
* The RAC may not send traps when your system is locked up.
To enable traps to be sent when the system is locked, configure
the watchdog timer using the Server Administrator GUI. In the
Server Administrator GUI, click the "Properties" tab and ensure
that the "Auto Recovery" is selected. The default value of the
"Action On Hung Operating System Detection" setting is "None".
"None" indicates that detection will not be performed.
* Depending on your network and proxy configurations and whether
you are using Mozilla browser, you may need to
enter the exact IP address of the RAC controller you are
trying to access in the "No Proxy for" field of your browser.
Perform the following steps:
1. Open your Mozilla browser.
2. Click "Edit".
3. Click "Preferences".
4. Click "Advanced" in the left sidebar.
5. Click "Proxies" in the left sidebar.
6. Enter the RAC IP address in the "No Proxy for:" field.
7. Click "OK" and then close the browser.