Owner's Manual

file:///T|/htdocs/SOFTWARE/svradmin/6.0.3/readme/readme.txt[10/23/2012 1:29:23 PM]
The Auto Recovery feature is not enabled by default. If the Auto
Recovery feature has been enabled, increase the System Reset Timer
value to at least 120 seconds. [78425
* Using Internet Explorer browser, if you install Server Administrator
on a system that includes a underscore in its hostname, you must use
the target system's IP address in the browser's URL to launch Server
Administrator as Hostnames with underscores are not supported.
For example, if the ip address of the host is 192.168.2.3, and
Server Administrator listens to port 1311, then use the
URL https:192.168.2.3:1311. For more information, see the following
article on the Microsoft website:
http://support.microsoft.com/kb/312461
* If the Alert Log contains large number of entries and if you try to
navigate to another page, the Server Administrator GUI may become
unresponsive for approximately 30 seconds. [152755]
* If the CPU throttles, the following message in the hardware System
Event Log (SEL) will be displayed with an unknown severity:
System Board Power Optimized: Performance status sensor for System
Board, unknown event.
[175331]
* On certain systems that do not support power monitoring, Server
Administrator reports the two platform event filters related to
power monitoring as "System Power Probe Warning" and "System Power
Probe Failure". These two filters are not supported on these
systems. That is, you can view and configure these filters;
however no action will be taken. [172125]
* On Server Administrator, Under Asset Information->System Information
->Primary User Telephone Number configuration allows only
alphanumerics. [185770
* While installing Windows Server 2008 or post installation,if you
set the Time and Currency formats to any of the newly added
languages (in comparison with Windows Server 2003), then DSM SA
Connection service and DSM SA Shared Service of OpenManage Server
Administrator may fail to start and Command Line Interface options
may fail to execute. [171026]
* The selection of default option for front panel LCD in Server
Administrator will display "Model Name" where as the default is
"Service Tag" on the physical LCD.
* In case server administrator does not respond to your
selections on the component tree, perform the following steps.
1. Click on Preferences. This will take you to the preferences page
2. Click on the Server administrator
3. Now the items on the front page might respond to your click.