User's Manual

Does my controller support this feature? See "Supported Features."

Use the Assign Dedicated Hot Spare task to assign a disk as a backup for a single virtual disk. See "Assign and Unassign Dedicated Hot Spare" for more
information.

Check Consistency

Does my controller support this feature? See "Supported Features."

Use the Check Consistency task to verify the accuracy of the redundant (parity) information. This task only applies to redundant virtual disks. When
necessary, the Check Consistency task rebuilds the redundant data. If the virtual disk is in a Failed Redundancy state, running a check consistency may return
the virtual disk to a Ready state.

Cancel Check Consistency

Does my controller support this feature? See "Supported Features."

Use the Cancel Check Consistency task to stop a check consistency operation that is in progress.

Pause Check Consistency

Does my controller support this feature? See "Supported Features."

Use the Pause Check Consistency task to pause a check consistency while it is in progress.


Resume Check Consistency

Does my controller support this feature? See "Supported Features."

Use the Resume Check Consistency task to resume a check consistency after it has been paused.

Blink and Unblink (Virtual Disk)

Does my controller support this feature? See "Supported Features."

The Blink and Unblink tasks blink or unblink the lights on the physical disks included in the virtual disk. See "Blink and Unblink (Virtual Disk)" for more
information.

Rename

Does my controller support this feature? See "Supported Features."
NOTE: The Pause Check Consistency task updates the virtual disk state property to Resynching Paused immediately. The progress property may
continue to increment for up to three seconds. This time delay occurs because the polling task may take up to three seconds to query the task
information and update the display.