Users Guide

omconfig Cancel Replace Member

Does my controller support this feature? See "Supported Features."

Use the following omconfig command syntax to cancel a replace member operation.

Complete Syntax

action=cancelreplacemember controller=id pdisk= <PDISKID>

where id is the physical disk IDs as reported by the omreport command.

Example Syntax

For example, to cancel replace member operation on physical disk 0:0:1, which is connected to controller 0, you would enter:

omconfig storage pdisk action=cancelreplacemember controller=0 pdisk=0:0:1

omconfig Battery Commands

The following sections provide the omconfig command syntax required to execute battery tasks.

Table 15-18. omconfig Battery Commands

omconfig Recondition Battery

Does my controller support this feature? See "Supported Features."

Use the following omconfig command to recondition a controller battery. For more information on batteries and the recondition process, see "RAID Controller
Batteries" and "Recondition Battery."

Complete Syntax

omconfig storage battery action=recondition controller=id battery=id

where id is the controller ID and battery ID as reported by the omreport command. To obtain this value, you would enter omreport storage controller to
display the controller IDs and then enter omreport storage battery controller=ID to display the ID for the controller battery.

Required Command Levels (1, 2, 3)
Optional name=value Pairs
Documentation Section
omconfig storage battery


action=recondition controller=id battery=id
"omconfig Recondition Battery"
action=startlearn controller=id battery=id
"omconfig Start Battery Learn Cycle"
action=delaylearn controller=id battery=id days=d hours=h
"omconfig Delay Battery Learn Cycle"