Users Guide

Does my controller support this feature? See "Supported Features."

Use the following omconfig command syntax to pause a check consistency while it is in progress. See "Pause Check Consistency" for more information.

Complete Syntax

omconfig storage vdisk action=pausecheckconsistency controller=id vdisk=id

where id is the controller ID and virtual disk ID as reported by the omreport command. To obtain these values, you would enter omreport storage controller to
display the controller IDs and then enter omreport storage vdisk controller=ID to display the IDs for the virtual disks attached to the controller.

Example Syntax

For example, to pause a check consistency on virtual disk 4 on controller 1, you would enter:

omconfig storage vdisk action=pausecheckconsistency controller=1 vdisk=4

omconfig Resume Check Consistency

Does my controller support this feature? See "Supported Features."

Use the following omconfig command syntax to resume a check consistency after it has been paused.

Complete Syntax

omconfig storage vdisk action=resumecheckconsistency controller=id vdisk=id

where id is the controller ID and virtual disk ID as reported by the omreport command. To obtain these values, you would enter omreport storage controller to
display the controller IDs and then enter omreport storage vdisk controller=ID to display the IDs for the virtual disks attached to the controller.

Example Syntax

For example, to resume a check consistency on virtual disk 4 on controller 1, you would enter:

omconfig storage vdisk action=resumecheckconsistency controller=1 vdisk=4

omconfig Delete Virtual Disk

Does my controller support this feature? See "Supported Features."

Use the following omconfig command syntax to delete a virtual disk.
