Users Guide

For example, to blink the physical disks in virtual disk 4 on controller 1, you would enter:

omconfig storage vdisk action=blink controller=1 vdisk=4

omconfig Unblink Virtual Disk

Does my controller support this feature? See "Supported Features."

Use the following omconfig command syntax to unblink the physical disks included in a virtual disk.

Complete Syntax

omconfig storage vdisk action=unblink controller=id vdisk=id

where id is the controller ID and virtual disk ID as reported by the omreport command. To obtain these values, you would enter omreport storage controller to
display the controller IDs and then enter omreport storage vdisk controller=ID to display the IDs for the virtual disks attached to the controller.

Example Syntax

For example, to blink the physical disks in virtual disk 4 on controller 1, you would enter:

omconfig storage vdisk action=unblink controller=1 vdisk=4

omconfig Initialize Virtual Disk

Does my controller support this feature? See "Supported Features."

Use the following omconfig command syntax to initialize a virtual disk. See "Format and Initialize; Slow and Fast Initialize" for more information.

Complete Syntax

omconfig storage vdisk action=initialize controller= id vdisk=id

where id is the controller ID and virtual disk ID as reported by the omreport command. To obtain these values, you would enter omreport storage controller to
display the controller IDs and then enter omreport storage vdisk controller=ID to display the IDs for the virtual disks attached to the controller.

Example Syntax

For example, to initialize virtual disk 4 on controller 1, you would enter:

omconfig storage vdisk action=initialize controller=1 vdisk=4
