Users Guide
Example Syntax
For example, to quiet the alarm on controller 1, you would enter:
omconfig storage controller action=quietalarm controller=1
omconfig Test Controller Alarm
Does my controller support this feature? See "Supported Features."
Use the following omconfig command syntax to test whether the controller alarm is functional. The alarm will sound for about two seconds. See "Test Alarm
(Controller)" for more information.
Complete Syntax
omconfig storage controller action=testalarm controller=id
where id is the controller ID as reported by the omreport storage controller command.
Example Syntax
For example, to test the alarm on controller 1, you would enter:
omconfig storage controller action=testalarm controller=1
omconfig Reset Controller Configuration
Does my controller support this feature? See "Supported Features."
Use the following omconfig command syntax to reset the controller configuration.
Complete Syntax
omconfig storage controller action=resetconfig controller=id
where id is the controller ID as reported by the omreport storage controller command.
In some circumstances, you may receive a warning message if this command will delete the system or boot partition. You can override this warning by using
CAUTION: Resetting a configuration permanently destroys all data on all virtual disks attached to the controller. If the system or boot partition
resides on these virtual disks, it will be destroyed. You may receive a warning message if this command will result in deleting the system or boot
partition. However, this warning message is not generated in all circumstances. You should be certain that you are not deleting the system or
boot partition or other vital data when using this command.
NOTE: Resetting the controller configuration does not remove a foreign configuration. To remove a foreign configuration, use the "omconfig Clear
Foreign Configuration" command. See "Clear Foreign Configuration" for more information.