Users Guide

Use the following omconfig command syntax to rescan all controllers on the system. See "Rescan Controller" and "Rescan to Update Storage Configuration
Changes" for more information about using this command.

Complete Syntax

omconfig storage globalinfo action=globalrescan

Example Syntax

The omconfig command syntax for rescanning all controllers on the system does not require that you specify a controller ID. To do a global rescan of all
controllers, enter the following:

omconfig storage globalinfo action=globalrescan


omconfig Controller Commands

The following sections provide the omconfig command syntax required to execute controller tasks.

Table 15-15.omconfigControllerCommands
NOTE: Global Rescan is not supported on non-RAID controllers. On non-RAID controllers, you must reboot the system before Storage Management can
see configuration changes.
Required
Command
Levels (1, 2,
3)
Optional name=value Pairs
Documentation
Section
omconfig
storage
controller



action=rescan controller=id
"omconfig Rescan
Controller"

action=enablealarm controller=id
"omconfig Enable
Controller Alarm"

action=disablealarm controller=id
"omconfig Disable
Controller Alarm"

action=quietalarm controller=id
"omconfig Quiet
Controller Alarm"

action=testalarm controller=id
"omconfig Test
Controller Alarm"

action=resetconfig controller=id [force=yes]
"omconfig Reset
Controller
Configuration"

action=createvdisk controller=id raid=<c| r0| r1| r5| r6 | r10| r50 | r60> size=<number | max | min>
pdisk=<PDISKID> [stripesize=< 2kb| 4kb| 8kb| 16kb| 32kb| 64kb| 128kb>] [cachepolicy=<d | c>]
[diskcachepolicy=<d | e>] [readpolicy=<ra| nra| ara| rc| nrc>] [writepolicy=<wb | wt | wc | nwc | fwb>]
[name=<string>] [spanlength=<n>]
NOTE: For RAID 10 on SAS controllers with firmware version 6.1 and later, spanlength is an optional parameter
(default=2)
"omconfig Create
Virtual Disk"

action=setrebuildrate controller=id rate=<0 to 100>
"omconfig Set
Controller Rebuild
Rate"

action=setbgirate controller=id rate=<0 to 100>
"omconfig Set
Background
Initialization Rate"

action=setreconstructrate controller=id rate=<0 to 100>
"omconfig Set
Reconstruct Rate"

action=setcheckconsistency controller=id rate=<0 to 100>
"omconfig Set Check
Consistency Rate"

action=exportlog controller=id
"omconfig Export the
Controller Log"

action=importforeignconfig controller=id
"omconfig Import