Users Guide
omreport Virtual Disk Status
Table 15-13. omreport Virtual Disk Commands
omconfig Global Commands
The following sections provide the omconfig command syntax required to execute the global commands. When executed, these commands apply to all
controllers. These global commands also correspond to the global tasks provided by the Storage tree view object's Information/Configuration subtab. See
"Global Tasks" for more information.
Table 15-14.omconfigGlobalCommands
omconfig Global Enable Smart Thermal Shutdown
Does my controller support this feature? See "Supported Features."
Bydefault,theoperatingsystemandservershutdownwhenthePowerVault™220SandPowerVault221Senclosuresreachacriticaltemperatureof0or50
degrees Celsius. If you have implemented connector redundancy on the PowerVault 220S and PowerVault 221S enclosures, however, you can specify that
only the enclosure and not the operating system and server be shut down when the enclosure reaches a critical temperature of 0 or 50 degrees Celsius.
Specifying that only the enclosure be shutdown during excessive temperatures is known as smart thermal shutdown. See "Channel Redundancy and Thermal
Shutdown" for more information.
controller number. For
example: controller=0
another disk as part of the replace member
operation, the state of the physical disk is
displayed as Replacing. See "Revertible Hot
Spare" for more information.
connector=id
where id is the connector number. For example: connector=1
Displays all physical disks attached to the
specified connector on the controller.
vdisk=id
where id is the virtual disk number. For example: vdisk=1
Displays all physical disks included in the
specified virtual disk on the controller.
pdisk=connector:targetID
where connector is the connector number and targetID is the physical disk
number. For example: pdisk=0:3
Displays the specified physical disk on the
specified connector on a SCSI, SATA, or ATA
controller.
pdisk=connectorID:targetID|connectorID:enclosureID:slotID
where connectorID:targetID is the connector number and the physical disk number
and connectorID:enclosureID:slotID is the connector number, enclosure number,
and slot number.
For example: pdisk=0:2 or pdisk=0:1:2
Displays the specified physical disk on the
specified connector and enclosure on a SAS
controller.
Required Command Levels
(1, 2, 3)
Optional name=value Pairs
Use
omreport storage vdisk
Displays property information for all virtual disks
on all controllers.
controller=id
where id is the controller number. For example: controller=0
Displays all virtual disks on the specified
controller.
controller=id vdisk=id
where id is the controller number and the virtual disk number. For
example: controller=0 vdisk=1
Displays the specified virtual disk on the
controller.
Required Command Levels (1, 2, 3)
Optional name=value Pairs
Documentation Section
omconfig storage globalinfo
action=enablests
"omconfig Global Enable Smart Thermal Shutdown"
action=disablests
"omconfig Global Disable Smart Thermal Shutdown"
action=globalrescan
"omconfig Global Rescan"