User's Manual

92 omconfig: Managing Components Using the Instrumentation Service

Index 0 always defaults to the main system chassis. The following command

omits index=n, but accomplishes the same thing:

omconfig chassis info tag=buildsys

omconfig mainsystem info tag=buildsys

An acceptable command, when executed, results in the following message:

Chassis info set successfully.

For some chassis, you can assign a different name. You cannot rename the

main system chassis. In the example below, the command renames chassis 2

from storscsi1 to storscsia:

omconfig chassis info index=2 name=storscsia

omconfig mainsystem info index=2 name=storscsia

As with other commands, the CLI issues an error message if you do not have a

chassis 2 (the main chassis=0). The CLI allows you to issue commands only

for the system configuration you have.

omconfig chassis leds/omconfig mainsystem leds

Use the omconfig chassis leds or omconfig mainsystem leds command to

specify when to flash a chassis fault LED or chassis identification LED.

This command also allows you to clear the LED for the system's hard drive.

Table 4-8 shows the valid parameters for the command.

Table 4-8. omconfig chassis leds/omconfig mainsystem leds

name=value pair 1 name=value pair 2 Description

index=<n> NA Number of the chassis where the LED resides

(defaults to chassis 0, main system chassis).

led=fault severity=warning | critical Select to flash the LED either when a warning

event occurs or when a critical event occurs.

led=hdfault action=clear Sets the number of faults for the hard drive

back to zero (0).

led=identify flash=off | on

time-out=<n>

Sets the chassis identification LED to off or on.

Set the time-out value for the LED to flash to a

number of seconds.