User's Manual

80 omconfig: Managing Components Using the Instrumentation Service
Table 4-3 shows the name=value pairs you can use with this command.
Table 4-3. BIOS Setup Settings
name=value pair 1
attribute=
name=value pair 2
setting=
Description
attribute=
acpwrrecovery
setting=off | last| on off: System is turned off.
last: System returns to previous state.
on: System is turned on.
delay=random |
immediate | timedelay
time <value>
random: System is turned on with random
delay.
immediate: System returns to previous state
immediately.
timedelay <value>: System is turned on
based on user specified time delay.
attribute=bezel setting=enable | disable enable: Enables the bezel removal intrusion
check during system boot.
disable: Disables the bezel removal intrusion
check during system boot.
attribute=
bootsequence
setting=diskettefirst |
hdonly | devicelist
|cdromfirst | opticaldrive
Instructs the BIOS which device is used to
boot the system, and the order in which the
boot routine is to check each device.
attribute=
conredirect
setting=enable | disable enable: Redirects the BIOS screen over Serial
Port 1. Keyboard and text output are
redirected over Serial Port 2.
disable: Turns off the BIOS console
redirection.
attribute=crab setting=enable | disable enable: Enables BIOS console redirection
after system reboot.
disable: Disables BIOS console redirection.
NOTE: The command crab is valid for Dell
PowerEdge x9xx systems only.
attribute=cpuht setting=enable | disable enable: Enables logical processor
hyperthreading.
disable: Disables logical processor
hyperthreading.
attribute=cpuvt setting=enable | disable enable: Enables virtualization.
disable: Disables virtualization.