User's Manual

omreport: Viewing System Status Using the Instrumentation Service 57
NOTE: As with all output shown in this guide, the following output is an example
and may vary depending on your system configuration.
Commands for Viewing Logs
You can use the omreport system or omreport servermodule command to
view logs: the alert log, the command log, and the hardware or ESM log.
NOTE: If the Alert log or Command log displays invalid XML data (such as when
XML data generated for the selection is not well-formed), to clear the log and
resolve the issue."
omconfig system alertlog action=clear" or
"omconfig system cmdlog action=clear" resolves the issue.
If you need to retain the log information for future reference, save a copy of the log
before clearing. See "Commands for Clearing Logs" for more information about
clearing logs.
To view the contents of the alert log, type:
omreport system alertlog
or
omreport servermodule alertlog
To view the contents of the command log, type:
omreport system cmdlog
or
omreport servermodule cmdlog
To view the contents of the ESM log, type:
omreport system esmlog
or
omreport servermodule esmlog
Overall Health Status of the ESM Log
When you type omreport system esmlog or omreport servermodule esmlog,
the Embedded Systems Management (ESM) report displays. The first line of
the report reflects the overall health of the system hardware. For example,
SEVERITY : COMPONENT
Ok : Main System Chassis
Critical : Storage