User's Manual

32 omreport: Viewing System Status Using the Instrumentation Service
Help With the omreport Command
Use the omreport -? command to get a list of the available commands for
omreport.
Use omreport
<command level 2> -? to get help on the level 2 about, chassis,
and system commands. The following information on omreport system -?
applies also applies to get help for the omreport chassis command.
To see a list of valid commands for omreport system, type:
omreport system -? | more
omreport modularenclosure
Use the omreport modularenclosure command to view details of the modular
system. Type:
omreport modularenclosure
NOTE: This CLI command is available when Dell OpenManage Server
Administrator is installed on Dell modular systems.
Server Administrator displays information related to the modular enclosure
and chassis management controller CMC (if available):
NOTE: As with all output shown in this guide, the following output is an example
and may vary depending on your system configuration.
summary U, P, A Shows the key facts for all system
components, including main system
chassis, software, and storage.
thrmshutdown P, A Shows the shutdown action, if any, to be
taken when a temperature warning or
failure condition is detected.
version U, P, A Shows a summary for all updatable
components on your system.
Table 3-2. Command Level 1, Level 2, and Level 3 for omreport (continued)
Command
Level 1
Command
Level 2
Command
Level 3
User
Privilege
Required
Use