User's Manual

30 omreport: Viewing System Status Using the Instrumentation Service
info U, P, A Shows a status summary for main system
chassis components.
intrusion U, P, A Shows the status of the system’s
intrusion sensor(s).
leds U, P, A Shows the properties you have set for
light-emitting diodes to flash under
various alert conditions.
memory U, P, A Shows properties of your system's
memory arrays.
nics U, P, A Shows the number of NICs installed in
your system and displays controller and
interface related details.
ports U, P, A Shows the properties for your system’s
parallel and serial ports, such as I/O
address, IRQ level, connector type, and
maximum speed.
processors U, P, A Shows properties of your system’s
processors, including speed,
manufacturer, and processor family.
pwrmanagement U, P, A Shows power management profiles that
will provide control over power
utilization.
pwrmonitoring U, P, A Shows properties of power consumption.
pwrsupplies U, P, A Shows properties of power supplies.
remoteaccess U, P, A Shows general information on remote
access.
slots U, P, A Shows properties of your system’s
expansion slots and other slot types.
temps U, P, A Shows the status and thresholds for the
system temperature sensors.
volts U, P, A Shows the status and thresholds for the
system voltage sensors.
Table 3-2. Command Level 1, Level 2, and Level 3 for omreport (continued)
Command
Level 1
Command
Level 2
Command
Level 3
User
Privilege
Required
Use