User's Manual

190 Using the Storage Management Service
omconfig Resume Check Consistency
Use the following omconfig command syntax to resume a check consistency
after it has been paused.
Complete Syntax
omconfig storage vdisk action=
resumecheckconsistency controller=id vdisk=id
where id is the controller ID and virtual disk ID as reported by the omreport
command. To obtain these values, enter omreport storage controller to display
the controller IDs and then enter omreport storage vdisk controller=ID to
display the IDs for the virtual disks attached to the controller.
Example Syntax
To resume a check consistency on virtual disk 4 on controller 1, enter:
omconfig storage vdisk action=
resumecheckconsistency controller=1 vdisk=4
omconfig Delete Virtual Disk
Use the following omconfig command syntax to delete a virtual disk.
CAUTION: Deleting a virtual disk destroys all information including file systems
and volumes residing on the virtual disk. You may receive a warning message if
you attempt to delete the system or boot partition. However, this warning message
is not generated in all circumstances. Ensure that you are not deleting the system
or boot partition or other vital data when using this command.
Complete Syntax
omconfig storage vdisk action=deletevdisk
controller=id vdisk=id
wwon=deletevdisk controller=1 vdisk=4