User's Manual

18 Introduction
Table 1-1 lists the primary CLI commands used by Server Administrator.
This guide contains a section for each primary command.
NOTE: omupdate commands are no longer supported in Server Administrator and
are replaced by Dell Update Package or Server Update Utility commands. To update
the different components, download the Dell Update Package and run <package
name> /s [/f]. See the Dell Update Packages for Microsoft Windows Operating Systems
User’s Guide, the Dell Update Packages for Linux User’s Guide, or the Server Update
Utility User’s Guide for more information on corresponding CLI syntax.
Additional useful topics about the CLI include:
• "Working With CLI Command Results"
• "Glossary"
CLI Error Checking and Error Messages
When you type CLI commands, the CLI checks these commands for correct
syntax. If you enter a command and the command is executed successfully,
a message displays, stating that your command has been successful.
Success Messages
When you type a successful omconfig command, data for that
component displays.
The following omconfig command examples show valid CLI commands and
their success messages:
Command:
omconfig chassis temps index=0 warnthresh=default
Table 1-1. CLI Commands and Sections in This Guide
Primary CLI
Command
Section Title Related Sections
omconfig "omconfig: Managing Components
Using the Instrumentation Service"
"omconfig system or servermodule
assetinfo: Editing Cost of Ownership
Values"
omhelp "Using the omhelp Command"
omreport "omreport: Viewing System Status
Using the Instrumentation Service"