Read me

=====================================================================
* Due to resource non-availability, inventory collection may
terminate unexpectedly and restart. If this occurs, the folder
"C:\Temp\invcol" may be left as an artifact. The presence of this
folder does not affect functionality of the inventory collection.
The folder can be deleted if required. [138549]
* After installing Server Administrator from the command prompt,
issuing an "omreport" or "omconfig" command from the same
prompt can cause an error. Open a new command prompt and issue
commands from the new window.
* If the command log page in the Server Administrator GUI displays an
error message indicating that the XML is malformed, you must clear
the command log from the CLI using the "omconfig system cmdlog
action=clear" command.
* After a "Reset to Defaults" operation of the Integrated Dell
Remote Access Controller the first user configuration operation will
fail if it is a single user configuration item (such as enabling or
disabling a user or changing user name). Always change a combination
of two user configuration items (such as enabling or disabling a
user and changing user name) concurrently during your first
configuration operation.[136599]
* While browsing through IT Assistant, if the SNMP protocol is
disabled and the CIM protocol is enabled, the redundancy status is
shown as "lost" even though the system has full redundancy. To
confirm the correct state of the system, use the Server
Administrator user interface.
* If you have a RAID 1 virtual disk on a CERC SATA 1.5/6ch
controller, performing a "Format or Split Mirror" operation
may fail. Dell is working to resolve this problem.
* When issuing the Server Administrator command line "omreport
system version -outc <filename>", be sure to specify an absolute
path name for the output file, for example, "c:\out.txt";
otherwise, the output file will be empty.
* Issuing the "omreport system esmlog/alertlog/cmdlog -fmt tbl"
command on the CLI can result in XML parsing errors if the size
of the log is very large. Use the GUI or the "omreport system
esmlog/alertlog/cmdlog" CLI command to view the contents of
the log.[124997]
* For complex "omconfig" CLI commands that contain multiple
commands in one command line, the CLI may report a success status
for the command even if part of the command failed. To avoid this
issue, run only one command per command line. The current
settings can be confirmed by performing the corresponding
"omreport" command.
* Some complex "omconfig" CLI commands that contain multiple set
operations have been modified to avoid the above problem. If,
while executing a CLI command you receive the message "Error!