User's Manual

Using the Storage Management Service 191
omconfig Connector Commands
The following sections provide the omconfig command syntax required to
execute connector tasks.
omconfig Rescan Connector
Use the following omconfig command to rescan a controller connector. This
command rescans all connectors on the controller and is therefore similar to
performing a controller rescan.
NOTE: This command is not supported on SAS controllers.
Complete Syntax
omconfig storage connector action=rescan
controller=id connector=id
where id is the controller ID and the connector ID as reported by the omreport
command. To obtain these values, enter omreport storage controller to display
the controller IDs and then enter omreport storage connector controller=ID
to display the IDs for the connectors attached to the controller.
Example Syntax
To rescan connector 2 on controller 1, enter:
omconfig storage connector action=rescan
controller=1 connector=2
Table 6-25. omconfig Connector Commands
Required Command Levels (1, 2, 3) Optional name=value pairs
omconfig storage connector
action=rescan controller=id connector=id