User's Manual

150 Using the Storage Management Service
Complete Syntax
omconfig storage controller action=resetconfig
controller=id
where id is the controller ID as reported by the omreport storage controller
command.
In some circumstances, you may receive a warning message if this command
deletes the system or boot partition. You can override this warning by using
the force=yes parameter. In this case, the syntax is as follows:
omconfig storage controller action=resetconfig
controller=id force=yes
Example Syntax
To reset the configuration on controller 1, enter:
omconfig storage controller action=resetconfig
controller=1
omconfig Create Virtual Disk
The Dell OpenManage Online Help provides additional information about
creating virtual disks.
The omconfig syntax for creating a virtual disk has several parameters. You
must specify the following parameters:
• Controller (controller=id)
• RAID level (raid=<c| r0| r1| r1c| r5|r6| r10| r50|r60>)
• Size (size=<number | max | min>)
•
Physical disk is specified as either :
For SCSI, SATA, and ATA Controllers
pdisk=connector:enclosureID:portID
where connector:enclosureID:portID is the connector number, enclosure number,
and port number.
For example
pdisk=0:1:2