SNMP Reference Guide

660 Traps
Discrete voltage state:
<State>
Specifies the state of the voltage sensor, for
example:
Discrete voltage state: Good
Fan sensor value:
<
Reading >
Specifies the fan speed in revolutions per
minute (RPMs) or On/Off, for example:
Fan sensor value (in RPM): 2600
Fan sensor value: Off
Log type: <
Log type > Specifies the type of hardware log, for example:
Log type: Embedded Server
Management (ESM)
Memory device bank
location:
<
Bank name in chassis >
Specifies the name of the memory bank in the
system that generated the message, for
example:
Memory device bank location:
Bank_1
Memory device location:
<
Device name in
chassis
>
Specifies the location of the memory module
in the chassis, for example:
Memory device location: DIMM_A
Number of devices
required for full
redundancy: <
Number >
Specifies the number of power supply or
cooling devices required to achieve full
redundancy, for example:
Number of devices required for
full redundancy: 4
Possible memory module
event cause:
<list of
causes>
Specifies a list of possible causes for the
memory module event, for example:
Possible memory module event
cause: Single bit warning
error rate exceeded
Single bit error logging
disabled
Table 26-1. Trap Description Reference (continued)
Description Line Item Explanation
book.book Page 660 Tuesday, August 5, 2008 9:15 AM