Release Notes

file:///T|/htdocs/SOFTWARE/svradmin/5.5/en/README/readme_sa.txt[10/25/2012 1:19:17 PM]
in to the RAC.
Use one of these methods to correct this issue:
- Change your passwords before updating the firmware.
OR
- Use the following CLI command to change the password:
"omconfig rac users username=xx userpassword=yy"
where "xx" is the original userid and "yy" is the new password.
OR
- Change the password through Server Administrator using the "User"
tab. Ensure that the check box to change the password is checked.
Enter a new password, and then enter it again to validate the
change.
OR
- Use the racadm utility to change the password:
"racadm config -g cfgUserAdmin -o cfgUserAdminPassword
-i <usr_index> <new_pwd>"
where <usr_index> is the index of the user database entry to be
modified and <new_pwd> is the new password.
* Depending on your network and proxy configurations and whether you
are using Mozilla browser, you may need to
enter the exact IP address of the RAC controller you are trying to
access in the "No Proxy for" field of your browser.
Perform the following steps:
1. Open your Mozilla browser.
2. Click "Edit".
3. Click "Preferences ...".
4. Click "Advanced" in the left sidebar.
5. Click "Proxies" in the left sidebar.
6. Enter the RAC IP address in the "No Proxy for:" field.
7. Click "OK" and then close the browser.
* If the out-of-band RAC user interface was spawned off from the
Server Administrator home page with a Mozilla browser, strings with