Release Notes

file:///T|/htdocs/SOFTWARE/svradmin/5.5/en/README/readme_sa.txt[10/25/2012 1:19:17 PM]
3. Click "OK" and save the file to a temporary location (should
be your home directory, by default).
4. Close the browser after saving the file.
5. Restart the browser, and specify the Web address of the
"rac4vm.xpi" file (for example: file:///root/rac4vm.xpi).
6. Mozilla presents you with the "Software Installation" dialog:
Click the "Install" button to continue.
7. After installation completes, close and restart the browser.
8. Log in to DRAC 4, and navigate to the Virtual Media link.
The plug-in is installed and ready to use.
9. At this point, delete the "~/rac4vm.xpi" file.
* The cfgDNSServer1 and cfgDNSServer2 properties of group
cfgLanNetworking may be set to identical values while swapping
addresses. Some performance may be lost temporarily during the
swapping. The cfgLanNetworking group is configured using the
"racadm config" command.[132894]
--------------------------------------------------------------------
ISSUES FOR DRAC III, DRAC III/XT, ERA, AND ERA/O
--------------------------------------------------------------------
Download the readme for your RAC type from support.dell.com for
the latest information on all known issues.
* Remote Access Dial-Up Settings: If you change a DRAC III modem
"Dial Mode" setting to "Tone" or "Pulse" using Server Administrator,
IT Assistant displays the opposite setting.
---------------------------------------------------------------------
ISSUES FOR ALL OPERATING SYSTEMS
---------------------------------------------------------------------
* Server Administrator user interface and commands related to "local
authentication enable" are not applicable for RAC firmware 3.20.
The Active Directory authentication feature replaces the "local
operating system authentication" feature in this version of
firmware. Due to this change, the following commands will return
errors:
"racadm localauthenable"
"omconfig rac authentication"
* Due to fluctuations in the watchdog timer, the "Last Crash
Screen" may not be captured when the Automatic System Recovery is
set to a value of less than 30 seconds. To ensure correct
functioning of the Last Crash Screen feature, set the System Reset
Timer to at least 30 seconds.