Users Guide

114 Remote Access Controller
Configuring the SNMP Alert Properties
NOTE: You must have Administrator privileges in Server Administrator to use the
Remote Access Controller.
To configure the Remote Access Controller alert properties, perform the
following steps:
1
Click Modular Enclosure → System/Server Module → Main System
Chassis/Main System
→ Remote Access and then click the
Configuration tab.
2 Click SNMP .
3 Click Add or click the Destination IP Address to edit existing SNMP alert
properties.
4 Select the check box next to Enable SNMP Trap , if it is not already
selected.
5 Enter the SNMP community name to which the destination management
station belongs in the
Community field.
6 Enter a destination IP address of the management station to which you
want the DRAC to send SNMP traps when an event occurs in the
IP Address field.
7 Use the check boxes under Severity Configuration to specify the events
and the severity level that those events must have to trigger an alert action
from the DRAC.
The first (left-most) column of check boxes corresponds to the severity
level
Informational , the second column corresponds to the severity level
Warning , and the third column corresponds to the severity level Critical .
The last seven events can only report the severity level
Informational .
8 Click Apply Changes and then click OK to save your changes.