User's Manual

omconfig: Managing Components Using the Instrumentation Service 83
Default Warning Thresholds
NOTE: The capabilities for managing sensors vary by systems.
If you want to set both the upper and lower power consumption probe
warning threshold values to the recommended default value, type:
omconfig chassis pwrmonitoring index=0 warnthresh=
settodefault
or
omconfig mainsystem pwrmonitoring index=0
warnthresh=settodefault
You cannot default one value and set another. In other words, if you default
the minimum warning threshold value, you are also selecting the default
value for the maximum warning threshold value.
Specify a Value for Warning Thresholds
If you prefer to specify values for the power consumption probe warning
thresholds, you must specify the number of the probe you are configuring and
the minimum and/or maximum warning threshold value. In the following
example, the probe that is being configured is probe 4:
omconfig chassis pwrmonitoring index=4 warnthresh=
325
or
omconfig mainsystem pwrmonitoring index=4
warnthresh=325.
When you issue the command and the system sets the values you specify, the
following message appears:
Power consumption probe warning threshold(s) set
successfully.
omconfig chassis remoteaccess/omconfig mainsystem remoteaccess
NOTE: This command is applicable to PowerEdge x8xx and x9xx systems only.
Use the omconfig chassis remoteaccess or omconfig mainsystem
remoteaccess command to configure:
• Remote access on a local area network (LAN).
• The serial port for BMC or RAC, whichever is installed.