User's Manual

Using the Storage Management Service 131
Table 6-2. Syntax For Name=Value Pairs For Parameters
Syntax Description
controller=id Indicates the controller ID as reported by the omreport storage controller
command. To obtain these values, enter omreport storage
controller to display the controller IDs and then enter omreport
storage pdisk controller=id to display the IDs for the physical
disks attached to the controller.
For example, the controller=id parameter might be specified as
controller=1.
connector=id Indicates the connector ID as reported by the omreport command. To
obtain this value, enter omreport storage controller to display
the controller IDs and then enter omreport storage connector
controller=id to display the IDs for the connectors attached to the
controller.
For example, the connector=id parameter might be specified as
connector=2.
vdisk=id Indicates the virtual disk ID as reported by the omreport command. To
obtain this value, enter omreport storage controller to display
the controller IDs and then enter omreport storage vdisk
controller=id to display the IDs for the virtual disks on the
controller.
For example, the vdisk=id parameter might be specified as vdisk=3.
enclosure=
<ENCLOSUREID>
Indicates a particular enclosure by specifying either enclosure=
connector or enclosure=connector:enclosureID.
To obtain these values, enter omreport storage controller to
display the controller IDs and then enter omreport storage
enclosure controller=id to display the IDs for the enclosures
attached to the controller.
pdisk=<PDISKID> Indicates a particular physical disk by specifying either
connector:targetID or connector:enclosureID:portID.
To obtain the values for the connector, enclosure, and physical disk
(targetID or portID), enter omreport storage controller to
display the controller IDs and then enter omreport storage pdisk
controller=id to display the IDs for the physical disks attached to
the controller.
battery=id Indicates the battery ID as reported by the omreport command. To
obtain this value, enter omreport storage controller to display
the controller IDs and then enter omreport storage battery
controller=id to display the ID for the controller battery.