Messages Reference Guide

146 Index
146 Index
SAS management and
monitoring is not
possible., 121
The non-RAID SCSI driver
version is older than the
minimum required
level.See the Readme file
for the validated driver
version., 94
The NVRAM has corrupt
data., 124
The NVRAM has corrupted
data. The controller is
reinitializing the
NVRAM., 124
The only hot spare available is
a SAS disk. SAS disks
cannot replace SATA
disks., 103
The only hot spare available is
a SATA disk. SATA disks
cannot replace SAS
disks., 102
The Patrol Read corrected a
media error., 110
The patrol read has
resumed., 114
The Patrol Read has
started., 105
The Patrol Read has
stopped., 105
The Patrol Read is
paused., 114
The Patrol Read mode has
changed., 105
The Patrol Read rate has
changed., 104
The physical disk blink has
ceased., 106
The physical disk blink has
initiated., 106
The physical disk Clear
operation failed., 110
The physical disk Clear
operation has
completed., 109
The physical disk Clear
operation has
started., 106
The physical disk has been
started., 107
The physical disk is not
certified., 131
The physical disk is not
supported., 103
The physical disk is too small
to be used for a
rebuild., 118
The physical disk rebuild has
resumed., 111
The power supply cable has
been inserted., 123
The power supply is switched
on., 123
The RAID controller firmware
and driver validation was
not performed. The
configuration file cannot
be opened., 93
The RAID controller firmware
and driver validation was
not performed. The
configuration file is out of
date or corrupted., 94
The rebuild failed due to
errors on the source
physical disk., 129
The rebuild failed due to
errors on the target
physical disk., 129
The SCSI Enclosure Processor
(SEP) has been rebooted
as part of the firmware
download operation and
will be unavailable until
the operation
completes., 133
The virtual disk cache policy
has changed., 101
The virtual disk Check
Consistency has made
corrections and
completed., 100
The virtual disk Read policy
has changed., 100
The virtual disk
reconfiguration has
resumed., 100
There is a bad sensor on an
enclosure., 116
There was an unrecoverable
disk media error during
the rebuild., 129
Thermal shutdown protection
has been initiated, 13