Messages Reference Guide

Index 145
The Check Consistency made
corrections and
completed., 128
The Check Consistency rate
has changed., 104
The Clear operation has
cancelled., 107
The controller alarm is
silenced., 104
The controller battery charge
level is below a normal
threshold., 112
The controller battery charge
level is normal., 95
The controller battery charge
level is operating within
normal limits., 112
The controller battery has
been removed., 96
The controller battery has
been replaced., 96
The controller battery is
charging., 106
The controller battery is
degraded., 106
The controller battery is
executing a Learn
cycle., 106
The controller battery Learn
cycle has been
postponed., 97
The controller battery Learn
cycle has completed., 97
The controller battery Learn
cycle has started., 97
The controller battery Learn
cycle has timed out., 97
The controller battery Learn
cycle will start in %
days., 98
The controller battery needs
to be replaced., 95
The controller battery
temperature is above
normal, 95
The controller battery
temperature is above
normal., 103
The controller battery
temperature is
normal., 95
The controller cache has been
discarded., 98
The controller debug log file
has been exported., 104
The controller has recovered
cached data from the
BBU., 127
The controller is unable to
recover cached data from
the battery backup unit
(BBU)., 127
The controller reconstruct
rate has changed., 109
The controller write policy
has been changed to
Write Back., 99
The controller write policy
has been changed to
Write Through., 99
The current kernel version
and the non-RAID SCSI
driver version are older
than the minimum
required levels.See the
Readme file for a list of
validated kernel and
driver versions., 94
The DC power supply is
switched off., 122
The dedicated hot spare is too
small., 111
The EMM has failed., 115
The enclosure cannot support
both SAS and SATA
physical disks. Physical
disks may be
disabled., 118
The enclosure has a hardware
error., 117
The enclosure is not
responding., 117
The enclosure is
unstable., 117
The enclosure temperature
has returned to
normal., 130
The factory default settings
have been restored., 127
The firmware on the EMMs is
not the same version.
EMM0 %1 EMM1 %2, 120
The global hot spare is too
small., 111
The initialization sequence of
SAS components failed
during system startup.