Read me

file:///T|/htdocs/SOFTWARE/svradmin/5.3/en/readme/readme_sa.txt[10/23/2012 1:36:11 PM]
The Auto Recovery feature can be set to execute an action (e.g.
reboot system) to recover a hung system. Since the Auto Recovery
timer is now an application level timer instead of a kernel level
timer, heavy resource stress on the system makes it more likely
that a short keep alive interval (less than 120 seconds) will not
be measured accurately, and the configured action may be triggered.
The issue will be more prevalent in systems which has only one CPU,
Hyper-Threading is not supported or is disabled, and the system is
subjected to persistent stressful conditions such as resource
depletion and CPU running at 100% usage with significantly more
threads than normal usage.
The Auto Recovery feature is not enabled by default. If the Auto
Recovery feature has been enabled, increase the System Reset Timer
value to at least 120 seconds. (78425)
* If you install Server Administrator on a system that includes a
underscore in its hostname, you must use the target system's ip
address in the browser's URL to launch Server Administrator as
Hostnames with underscores are not supported. For example (assuming
Server Administrator is listening on port 1311):
https://192.168.2.3:1311.
* If the Alert Log contains large number of entries and if you try
to navigate to other page Server Administrator GUI may become
unresponsive for approximately 30 seconds. (152755)
* If the CPU throttles, the following message in the hardware System
Event Log (SEL) will be displayed with an unknown severity:
System Board Power Optimized: Performance status sensor for System Board,
unknown event.
(175331)
* On certain systems that do not support power monitoring (please refer
to your Systems Users Guide for Power Monitoring support Information),
Server Administrator reports the two platform event filters related to
power monitoring as System Power Probe Warning and System Power Probe
Failure. These two filters are not supported on these systems. That is,
you can view and configure these filters; however no action will be
taken. (172125)
======================================================================
ISSUES FOR SERVER ADMINISTRATOR RUNNING ON ALL MICROSOFT WINDOWS
OPERATING SYSTEMS
======================================================================
* Execute all Server Administrator CLI commands from a 32-bit Windows
command prompt. Acceptable ways to access the 32-bit command prompt
are by clicking "Start-> Programs-> Accessories-> Command Prompt"
or by clicking "Start-> Run" and then typing "cmd.exe". Attempts to
run the CLI commands from the DOS command "command.com" may generate
unpredictable results.