Users Guide

82 omconfig: Managing Components Using the Instrumentation Service
omconfig chassis pwrmonitoring/omconfig mainsystem pwrmonitoring
Use the omconfig chassis pwrmonitoring or omconfig mainsystem
pwrmonitoring command to configure power consumption information.
NOTE: This command is applicable to selected Dell xx0x systems that supports
PMBus only.
Default Warning Thresholds
NOTE: The capabilities for managing sensors vary by systems.
If you want to set both the upper and lower power consumption probe
warning threshold values to the recommended default value, type:
omconfig chassis pwrmonitoring index=0 warnthresh=
settodefault
or
omconfig mainsystem pwrmonitoring index=0
warnthresh=settodefault
You cannot default one value and set another. In other words, if you default
the minimum warning threshold value, you are also selecting the default
value for the maximum warning threshold value.
Specify a Value for Warning Thresholds
If you prefer to specify values for the power consumption probe warning
thresholds, you must specify the number of the probe you are configuring and
the minimum and/or maximum warning threshold value. In the following
example, the probe that is being configured is probe 4:
Table 4-10. omconfig chassis pwrmonitoring/omconfig mainsystem pwrmonitoring
name=value pair 1 name=value pair 2 Description
index=<n> NA Number of the probe or probe index
(must be specified).
config=probe NA Sets the threshold value for the power
consumption probe.
warnthresh=settodefault NA Sets minimum and maximum warning
thresholds values to default.
warnthresh=<n> NA Sets a value for the warning threshold.
config=resetreading type=energy | peakpower energy: Resets the system energy reading.
peakpower: Resets the system peak power.