Users Guide

80 omconfig: Managing Components Using the Instrumentation Service

omconfig chassis info tag=buildsys

omconfig mainsystem info tag=buildsys

An acceptable command, when executed, results in the following message:

Chassis info set successfully.

For some chassis, you can assign a different name. You cannot rename the

main system chassis. In the example below, the command renames chassis 2

from storscsi1 to storscsia:

omconfig chassis info index=2 name=storscsia

omconfig mainsystem info index=2 name=storscsia

As with other commands, the CLI issues an error message if you do not have a

chassis 2 (the main chassis=0). The CLI allows you to issue commands only

for the system configuration you have.

omconfig chassis leds/omconfig mainsystem leds

Use the omconfig chassis leds or omconfig mainsystem leds command to

specify when to flash a chassis fault LED or chassis identification LED. This

command also allows you to clear the LED for the system's hard drive.

Table 4-8 shows the valid parameters for the command.

omconfig chassis memorymode/omconfig mainsystem memorymode

Use the omconfig chassis memorymode or omconfig mainsystem

memorymode command to specify the redundancy mode you want to use for

your system’s memory in case of memory errors.

Table 4-8. omconfig chassis leds/omconfig mainsystem leds

name=value pair 1 name=value pair 2 Description

index=<n> NA Number of the chassis where the LED resides

(defaults to chassis 0, main system chassis).

led=fault severity=warning | critical Select to flash the LED either when a warning

event occurs or when a critical event occurs.

led=hdfault action=clear Sets the number of faults for the hard drive back

to zero (0).

led=identify flash=off | on

time-out=<n>

Sets the chassis identification LED to off or on.

Set the time-out value for the LED to flash to a

number of seconds.