Users Guide

176 Using the Storage Management Service
where id is the controller ID. The <PDISK> variable specifies the physical
disk.
To obtain these values, enter omreport storage controller to display the
controller IDs and then enter omreport storage pdisk controller=ID to
display the IDs for the physical disks attached to the controller.
Example Syntax
In this example, you want to initialize physical disk 3 on connector 0 of
controller 1. On a SAS controller, the physical disk resides in enclosure 2.
Example for SCSI, SATA, and ATA Controllers
To initialize the physical disk described in this example, enter:
omconfig storage pdisk action=initialize
controller=1 pdisk=0:3
Example for SAS Controllers
To initialize the physical disk described in this example, enter:
omconfig storage pdisk action=initialize
controller=1 pdisk=0:2:3
omconfig Offline Physical Disk
Use the following omconfig command syntax to offline a physical disk:
Complete Syntax
omconfig storage pdisk action=offline controller=
id pdisk=connectorID:targetID
where id is the controller ID and connectorID:targetID is the
connector number and physical disk number as reported by the omreport
command. To obtain these values, enter omreport storage controller to
display the controller IDs and then enter omreport storage pdisk controller=
ID to display the IDs for the physical disks attached to the controller.